Remove residue from the build plate with ease.
Sometimes 3D prints and adhesives can leave nasty residue on the build plate. PrintaClean is a powerful solvent to effectively remove this sticky residue from the build plate with ease so the next creation can start on a clean slate.
Let the build plate cool to room temperature. Then remove the build plate from the 3D printer and spray a good amount of the solution on it. Let the solution sit for 20-30 seconds to loosen the residue. Wipe off with a paper towel. Repeat if necessary or allow for a longer exposure time.
DANGER: Highly flammable liquid and vapour. Causes serious eye irritation. If medical advice is needed, have product container or label at hand. Keep out of reach of children. Keep away from heat/sparks/open flames/hot surfaces. — No smoking. If eye irritation persists: Get medical advice/attention. Dispose of contents/container in accordance with national regulations.